SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-007
14-145
STATUS SCSI Command
This command shows the WWNs for all disks in enclosure 1 connected to SAC 2:
-> STATUS SAC.#FCSA.SAC-2.GRP-111.MOD-2.SLOT-1, &
-> EMU, DEVICEID (1,0)
STATUS SCSI Command
The STATUS SCSI command displays current status information about Open SCSI
devices. The syntax is:
Wild-card characters are supported.
OUT file-spec
directs all SCF output to the specified file.
SCSI $SCSI-device [-P |-B ]
is the name of the Open SCSI IOP and, optionally, the path (primary or backup).
DETAIL
displays detailed status information.
SEL state
specifies that the command affects only devices in the specified state.
STATUS SCSI Examples
•
To display the status of all Open SCSI devices on the system:
-> STATUS SCSI $*
•
To display the status of an Open SCSI device:
-> STATUS $DEV0
See the display and explanation under Example of a STATUS SCSI Report on
page 12-6.
•
To display detailed status of an Open SCSI device:
-> STATUS $DEV00, DETAIL
STORAGE - Emu Status SAC \OSM2.$ZZSTO.#FCSA.SAC-2.GRP-111.MOD-2.SLOT-1
Bay Port A WWN State Port B WWN State
1 2100000C502741B6 1 2200000C502741B6 1
2 2100000C50274285 1 2200000C50274285 1
3 2100000C5016D461 1 2200000C5016D461 1
4 2100000C502741E8 1 2200000C502741E8 1
STATUS [ / OUT file-spec / ] SCSI $SCSI-device[-P |-B ]
[ , DETAIL ] [ , SEL state ]