SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-007
14-150
STOP POOL Command
SEL state
specifies that the command affects only devices in the specified state.
STOP MON Example
See the procedure for Stopping the SMF Master Process on page 4-7.
To stop access to the SMF master process:
-> STOP $ZSMS
STOP POOL Command
The STOP POOL command stops access to the specified storage pool. The syntax is:
Wild-card characters are supported.
OUT file-spec
directs all SCF output to the specified file.
POOL $pool
is the storage pool process.
FORCED
specifies that the command be executed without any interaction with the user.
If you use this attribute, you must first stop all processes that use the disk to store
object code (programs) or swap files. Otherwise, a %5113 halt could occur.
SEL state
specifies that the command affects only devices in the specified state.
STOP POOL Example
See Stopping a Storage Pool on page 9-13.
To stop access to a storage pool process:
-> STOP $POOL00
STOP [ / OUT file-spec / ] POOL $pool
[ , FORCED ] [ , SEL state ]