SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-007
14-155
SWITCH Command
SWITCH Command
The SWITCH command designates the active a path to a device.
Supported objects are:
SWITCH is a sensitive command.
SWITCH ADAPTER Command
The SWITCH ADAPTER command moves all device paths from and to a SAC on an
adapter, as part of adapter replacement. The syntax is:
Wild-card characters are supported.
OUT file-spec
directs all SCF output to the specified file.
ADAPTER $ZZSTO.#type.GRP-g.MOD-m.SLOT-s
is a ServerNet adapter of type PMF, IOMF, or SNDA. g cannot have a leading
zero.
AWAY [ , FORCED ]
specifies that all active paths using the specified adapter become inactive, if
possible.
The FORCED attribute stops all paths to the specified adapter after attempting to
make them inactive.
DEFAULT [ , FORCED ]
specifies that all -P and -M paths using the specified adapter become active, if
possible, and all -B and -MB paths become inactive if possible.
The FORCED attribute starts all paths to the specified adapter before attempting to
make them active.
ADAPTER page 14-155
DISK page 14-156
SCSI page 14-157
SWITCH [ / OUT file-spec / ]
ADAPTER $ZZSTO.#type.GRP-g.MOD-m.SLOT-s
, { AWAY | DEFAULT } [ , FORCED ]