SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Error Messages
SCF Reference Manual for the Storage Subsystem—529937-007
B-5
Storage Subsystem Error Messages
•
The device being serviced
Effect. The command is not executed. SCF waits for the next command.
Recovery.
1. Verify the state of the device using the SCF STATUS command.
2. If needed, use the SCF RESET command to change the state of the device before
retrying the operation.
00010
Cause. The command was rejected by the storage subsystem manager process
($ZZSTO). This situation might be caused by mismatched versions of the storage
subsystem manager process and SCF.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Check product versions with the SCF VERSION command and install the
correct software, if necessary.
00011
vernum
is the version number of the down-version system.
Cause. The command was rejected by the storage subsystem manager process
($ZZSTO) because the information requested by the command cannot be obtained
from an older system.
Effect. The command is not executed. SCF waits for the next command.
Recovery. To resolve the version mismatch, contact your service provider.
00012
objtype
is the object type of the object you specified with the command.
STORAGE 00010 Negative response received from Storage
Subsystem Manager.
STORAGE 00011 Not supported by the down-version system
(vernum).
STORAGE 00012 Wrong state for objtype devname, state: state