SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Error Messages
SCF Reference Manual for the Storage Subsystem—529937-007
B-9
Storage Subsystem Error Messages
Recovery. The recovery action depends on the cause:
1. Use the SCF START command. If the processor is not down, the START
command will restart the IOP process.
2. If the processors are down, reload the processors. For instructions about how to
reload processors, see the NonStop S-Series Operations Guide.
If the problem persists, contact your service provider. See If You Have to Contact Your
Service Provider on page B-1.
00019
Cause. You specified too many processors in the command.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Correct the number of processors specified and repeat the command.
00020
Cause. The customer-replaceable unit (CRU) installed in the specified location is not
supported by the storage subsystem.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Move the CRU into the correct location. If the problem persists, contact
your service provider. See If You Have to Contact Your Service Provider on page B-1.
00021
Cause. You did not specify the PRIMARYCPU attribute with the command.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Reissue the command with the PRIMARYCPU attribute.
STORAGE 00019 Invalid processor count specified in access
list.
STORAGE 00020 Non-supported CRU type inserted in location.
STORAGE 00021 Required attribute not specified: PRIMARYCPU