SCF Reference Manual for the Storage Subsystem (G06.24+, H06.03+)

Storage Subsystem Error Messages
SCF Reference Manual for the Storage Subsystem—529937-007
B-22
Storage Subsystem Error Messages
Cause. You requested information for a CRU, but that information was unavailable
from the hardware inventory table.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Verify the hardware is actually present and connected correctly.
00062
errnum
is the error number returned from the PROCESS_LAUNCH_ procedure.
text
is additional information about the error.
Cause. The storage subsystem was unable to create the process.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Refer to the error number and error detail for the cause of the error and
retry the command. If the problem persists, contact your service provider. See If You
Have to Contact Your Service Provider on page B-1.
00063
cmd
is the command you specified.
sacpath
is the path of the ServerNet addressable controller (SAC) specified in the
command.
Cause. You attempted to configure a SAC for a device that the SAC does not
support.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Resolve the cause of the failure and reissue the command.
STORAGE 00062 Error from PROCESS_LAUNCH_, error: errnum,
error detail: text.
STORAGE 00063 cmd failed. SAC in use by incompatible
devices, sacpath.