SCF Reference Manual for the Storage Subsystem (G06.27+, H06.04+)

Storage Subsystem Commands

SCF Reference Manual for the Storage Subsystem—529937-008

14-37

ADD PROFILE Command

The ADD PROFILE command adds a profile to the system configuration database for

use in autoconfiguration of internal disks. The syntax is:

Wild-card characters are supported.

OUT file-spec

directs all SCF output to the specified file.

PROFILE $ZZSTO.INTERNAL-DISK-groupnum

is a custom profile for enclosure groupnum. groupnum cannot have a leading

zero.

SENDTO STORAGE

directs the command to the storage subsystem. This attribute is required unless

you specified SENDTO STORAGE in a previous ASSUME command.

LIKE object

identifies an existing object whose attribute values are copied to the object affected

by this command. The object name must currently exist in the system

configuration, and the object type must match that of the object affected by this

command. If you specify LIKE, any attribute values that you explicitly specify

override the attribute values of the LIKE object.

attribute-spec

is one or more PROFILE Attributes. Some disk attributes, like PRIMARYCPU, are

not kept in a profile because they are determined by the location of the disk.

PROFILE Attributes

For a description of these attributes, see Disk Attribute Descriptions on page 14-12.

[ , AUDITTRAILBUFFER number ]

[ , AUTOLABEL { ON | OFF } ]

[ , AUTOREVIVE { ON | OFF } ]

[ , AUTOSELECT { ON | OFF } ]

[ , AUTOSTART { ON | OFF } ]

[ , CBPOOLLEN number ]

ADD [ / OUT file-spec / ]

PROFILE $ZZSTO.INTERNAL-DISK-groupnum

, SENDTO STORAGE

[ , LIKE object ] [ , attribute-spec ]...