SCF Reference Manual for the Storage Subsystem (G06.27+, H06.04+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-008
14-40
ADD SCSI Command
BACKUPLOCATION ( group,module,slot )
is the location of the adapter that controls the backup path to the device. This
attribute has no default value. If this attribute is not specified, the device is not
accessible through its backup path.
BACKUPPORTNAME number
is the Fibre Channel port name used by the backup path to the Open SCSI device.
The number should be entered as a 16 character hexadecimal number, without a
leading %H.
BACKUPSAC { number | name }
is the SAC that controls the backup path to the device.
HIGHPIN { ON | OFF }
specifies whether the IOP can run at a high PIN (ON, the default) or only at a low
PIN (OFF).
LUN number
is the logical unit number (LUN) of a device connected to the Open SCSI device.
For devices connected to a SCSI controller number is in the range 0 through 7.
For Fibre Channel devices number is in the range 0 through 32767.
MAXOPENS number
is the maximum number of concurrent opens allowed for the device. number is in
the range 1 through 64. The default is 3.
NUMIO number
is the number of concurrent I/O operations that the Open SCSI IOP can have
outstanding. This value determines the size of the allocated data-buffer area.
number is in the range 1 through 15. The default is 8.
PRIMARYCPU number
is the processor in which the primary IOP starts. If you omit this attribute, the
processor is automatically chosen based on the physical location of the device.
number is the SAC subdevice number on the adapter.
If you specify BACKUPSAC in number format, you must also specify
BACKUPLOCATION.
name is the full name of the SAC location. For example:
SNDA.SAC-1.GRP-1.MOD-1.SLOT-53