SCF Reference Manual for the Storage Subsystem (G06.27+, H06.04+)

Storage Subsystem Commands

SCF Reference Manual for the Storage Subsystem—529937-008

14-53

ALTER MON Command

The ALTER MON command changes the configured attribute values for the SMF

master process. The syntax is:

Wild-card characters are supported.

OUT file-spec

directs all SCF output to the specified file.

MON $ZSMS

is the SMF master process.

attribute-spec

is one or more ALTER MON Attributes.

ALTER MON Attributes

[ , BACKUPCPU number ]

[ , HIGHPIN { ON | OFF } ]

[ , MODE { NOISY | QUIET } ]

[ , PRIMARYCPU number ]

[ , PROGRAM [[$vol.]subvol.]fileid ]

BACKUPCPU number

is the processor in which the backup IOP starts. The process must be in the

STOPPED state or not running for you to alter this attribute.

HIGHPIN { ON | OFF }

specifies whether the IOP can run at a high PIN (ON, the default) or only at a low

PIN (OFF).

MODE { NOISY | QUIET }

specifies whether to generate additional EMS messages for debugging.

PRIMARYCPU number

is the processor in which the primary IOP starts. The process must be in the

STOPPED state or not running for you to alter this attribute.

ALTER [ / OUT file-spec / ] MON $ZSMS

[ , attribute-spec ]...

NOISY Generate additional EMS messages for debugging.

QUIET Generate only essential EMS messages (default).