SCF Reference Manual for the Storage Subsystem (G06.27+, H06.04+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-008
14-102
REPLACE SAC Command
FIRMWARE [[$volume.]subvol.]filename
specifies the name of the new operational firmware file. The file must exist and
must have a file code of 510. The default volume and subvolume are equal to the
current SYSnn. The adapter name must be given as $ZZSTO.#*.
FLASHBOOT [[$volume.]subvol.]filename
specifies the name of the new flash boot file. The file must exist and must have a
file code of 510. The default volume and subvolume are equal to the current
SYSnn. This attribute can be used only with Fibre Channel ServerNet adapters
(FCSAs).
FLASHFIRMWARE [[$volume.]subvol.]filename
specifies the name of the new flash firmware file. The file must exist and must have
a file code of 510. The default volume and subvolume are equal to the current
SYSnn. This attribute can be used only with FCSAs.
For considerations regarding these attributes, see Considerations for REPLACE
ADAPTER on page 11-23.
REPLACE SAC Command
For an M8xxx FCDM connected to an FCSA, the REPLACE SAC command
downloads new firmware to an EMU connected to the SAC.
The syntax is:
OUT file-spec
directs all SCF output to the specified file.
#sac-name
is the name of the SAC in the form #FCSA.SAC-sac.GRP-group.MOD-
module.SLOT-slot. For example:
#FCSA.SAC-2.GRP-110.MOD-2.SLOT-5
DEVICEID (shelf, 99)
specifies the shelf number of the enclosure to which the command applies. The
bay number 99 designates the EMU.
REPLACE [ /OUT file-spec/ ] SAC $ZZSTO.#sac-name
[ , DEVICEID (shelf, 99) ]
[ , FIRMWARE [[$volume.]subvol.]filename ]