SCF Reference Manual for the Storage Subsystem (G06.27+, H06.04+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-008
14-119
STATUS DISK Command
VPROCS
displays only the full VPROC strings for firmware. See Example of a STATUS
FCSA ADAPTER, VPROCS Report on page 11-17.
STATUS ADAPTER Examples
•
To display the status of the PMF CRU adapter in group 01, slot 50:
-> STATUS ADAPTER $ZZSTO.#PMF.GRP-1.MOD-1.SLOT-50
See the display and explanation under Example of a STATUS PMF ADAPTER
Report on page 11-8.
•
To display detailed status of the PMF CRU adapter in group 01, slot 50:
-> STATUS ADAPTER $ZZSTO.#PMF.GRP-1.MOD-1.SLOT-50, DETAIL
See the display and explanation under Example of a Detailed STATUS PMF
ADAPTER Report on page 11-9.
•
To display the status of the 6760 ServerNet device adapter in group 01, slot 53:
-> STATUS ADAPTER $ZZSTO.#SNDA.GRP-1.MOD-1.SLOT-53
See the display and explanation under Example of a STATUS SNDA ADAPTER
Report on page 11-13.
STATUS DISK Command
The STATUS DISK command displays current status information about magnetic or
virtual disks. The syntax is:
Wild-card characters are supported.
OUT file-spec
directs all SCF output to the specified file.
DISK $disk[-P |-B |-M |-MB |-* ]
is the disk name and, optionally, the path (primary, backup, mirror, mirror backup,
or all paths).
STATUS [ / OUT file-spec / ]
DISK $disk[-P |-B |-M |-MB |-* ]
[ , { CONFIG | CONSISTENCY | DETAIL } ]
[ , POOL $pool ] [ , SEL state ]
[ , SUB { ALL | MAGNETIC | VIRTUAL } ]