SCF Reference Manual for the Storage Subsystem (G06.27+, H06.04+)

Storage Subsystem Commands

SCF Reference Manual for the Storage Subsystem—529937-008

14-127

STATUS SCSI Command

The STATUS SCSI command displays current status information about Open SCSI

devices. The syntax is:

Wild-card characters are supported.

OUT file-spec

directs all SCF output to the specified file.

SCSI $SCSI-device [-P |-B ]

is the name of the Open SCSI IOP and, optionally, the path (primary or backup).

DETAIL

displays detailed status information.

SEL state

specifies that the command affects only devices in the specified state.

STATUS SCSI Examples

•

To display the status of all Open SCSI devices on the system:

-> STATUS SCSI $*

•

To display the status of an Open SCSI device:

-> STATUS $DEV0

See the display and explanation under Example of a STATUS SCSI Report on

page 12-6.

•

To display detailed status of an Open SCSI device:

-> STATUS $DEV00, DETAIL

See the display and explanation under Example of a Detailed STATUS SCSI

Report on page 12-6.

STATUS SUBSYS Command

This subsection describes the details about the STATUS SUBSYS command. The

command syntax is:

STATUS [ / OUT file-spec / ] SCSI $SCSI-device[-P |-B ]

[ , DETAIL ] [ , SEL state ]

STATUS [ / OUT file-spec / ] SUBSYS $ZZSTO [ , DETAIL ]