SCF Reference Manual for the Storage Subsystem (G06.27+, H06.04+)

Storage Subsystem Commands
SCF Reference Manual for the Storage Subsystem—529937-008
14-128
STATUS TAPE Command
Wild-card characters are supported.
OUT file-spec
directs all SCF output to the specified file.
SUBSYS $ZZSTO
is the storage subsystem manager.
DETAIL
displays detailed status information.
STATUS SUBSYS Consideration
The information showed by INFO SUBSYS and STATUS SUBSYS should always be
the same. Contact your service provider if the information shown in these displays
differs.
STATUS SUBSYS Example
To display the summary status of storage subsystem manager:
-> STATUS SUBSYS $ZZSTO
See the display and explanation under Section 3, Using the Storage Subsystem
Manager.
STATUS TAPE Command
This subsection describes the details about the STATUS TAPE command. The
command syntax is:
Wild-card characters are supported.
OUT file-spec
directs all SCF output to the specified file.
TAPE $tape
is the name of the tape device.
DETAIL
displays detailed status information.
STATUS [ / OUT file-spec / ] TAPE $tape [ , DETAIL ]