SCF Reference Manual for the Storage Subsystem (G06.27+, H06.04+)

Storage Subsystem Error Messages
SCF Reference Manual for the Storage Subsystem—529937-008
B-17
Storage Subsystem Error Messages
00043
Cause. You specified a command that does not allow the specified device path.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Correct and reissue the command.
00044
Cause. The object is already configured. The indicated object might already be
configured by another device.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Correct the name of the object and reissue the command.
00045
Cause. The object is busy and will not accept commands. This situation might occur
when an IOP is unable to access its hardware. Usually a status query on the process
itself will show it in a wait state of %040 (INTR).
Effect. The command is not executed. SCF waits for the next command.
Recovery. Correct the hardware configuration and reissue the command.
00046
cmd
is the command that you issued.
Cause. You issued a RESET, FORCED command, which is used to stop and restart
the I/O process. You can use this command only in interactive mode.
Effect. The I/O process is restarted if you acknowledge the verification request.
Recovery. Informational message only; no corrective action is required.
STORAGE 00043 Wrong path specified: object-type name.
STORAGE 00044 Configuration database record already exists.
STORAGE 00045 IOP is busy.
STORAGE 00046 cmd will restart IOP.