SCF Reference Manual for the Storage Subsystem (G06.27+, H06.04+)

Storage Subsystem Error Messages
SCF Reference Manual for the Storage Subsystem—529937-008
B-34
Storage Subsystem Error Messages
2. Verify that the object you are using for the REPLACE, PROGRAM command is
compatible with the running object.
00091
Cause. You issued a REPLACE command, and one of two problems occurred:
•
The program file used for this command did not contain the expected version of the
procedure.
•
The version of the procedure did not indicate that it supported this command.
Effect. The command is not executed. SCF waits for the next command.
Recovery.
1. Contact your service provider. See If You Have to Contact Your Service Provider
on page B-1.
2. Obtain a new program file from your service provider.
3. Retry the command.
00092
Cause. An IOP did not respond within the timeout period, so CONFIG_INFO_
returned an unexpected error.
Effect. The command is not executed. SCF waits for the next command.
Recovery.
1. Retry the command.
2. If the problem persists, contact your service provider. See If You Have to Contact
Your Service Provider on page B-1.
00093
Cause. When you entered the command, you did not enter any attributes.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Enter the desired parameters. Retry the command.
STORAGE 00091 Unsupported program version.
STORAGE 00092 Unexpected error returned from CONFIG_GETINFO_,
the IOP did not respond within the allocated timeout period.
STORAGE 00093 No attributes have been specified for this
command.