SCF Reference Manual for the Storage Subsystem (G06.27+, H06.04+)

Storage Subsystem Error Messages
SCF Reference Manual for the Storage Subsystem—529937-008
B-36
Storage Subsystem Error Messages
Recovery. Handle those exceptions individually.
00098
Cause. The action was initiated successfully, but it has not yet finished.
Effect. The command is executed. This message is only a reminder.
Recovery. Use the STATUS command to monitor the progress of the action.
00099
Cause. The process cannot be terminated. An OSL process cannot be terminated
while it has paths in STARTED state.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Verify the state of the paths using the STATUS command. If needed, use
the STOP or ABORT command to change the state of the paths before retrying the
operation.
00100
Cause. Too many devices configured on a SAC or too many IOPs in the same
processor configured to use an adapter.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Configure fewer devices on the SAC or configure the IOP in different
processors.
00101
Cause. The specified attribute value conflicts with the device location.
Effect. The command is not executed. SCF waits for the next command.
Recovery. Specify attribute values and device location which are consistent with each
other.
STORAGE W00098 Action begun successfully, but not yet
finished. Monitor with STATUS.
STORAGE E00099 The process cannot be terminated.
STORAGE E00100 Command failed. Too many devices configured
on a SAC
STORAGE E00101 Attribute value conflicts with device
location.