SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

About This Document

This manual describes how to use the Subsystem Control Facility (SCF) to configure, control, and

inquire about storage subsystem objects on HP Integrity NonStop™ NS-series servers and HP

NonStop S-series servers. This manual is for anyone who configures new systems, changes or adds

to existing system configurations, plans changes to systems, monitors the status of the storage

subsystem, or operates a network of distributed systems. These devices are supported:

• Physical disks and virtual disks

• Tape drives

• Storage Management Foundation (SMF) objects

• Open SCSI and Open SCSI Fibre Channel objects

• ServerNet adapters

• CLuster I/O modules (CLIMs)

Supported Release Version Updates (RVUs)

This publication supports J06.03, H06.05, and G06.28.

Intended Audience

Anyone who is responsible for:

• Configuring new systems

• Changing or adding to existing system configurations

• Planning changes to systems

• Monitoring the status of the storage subsystem

• Operating a network of distributed systems

New and Changed Information

New and Changed Information in the February 2014 Edition

ChangeChapter

Updated syntax for “STATS DISK Command” (page 277)Chapter 14: “Storage Subsystem

Commands” (page 190)

Added the error messages 00145, 00146, and 00147 in “Storage

Subsystem Error Messages” (page 298)

Appendix A: “Storage Subsystem Error

Messages” (page 298)

Added a new consideration to “Considerations for WRITECACHE”

(page 94).

Chapter 6: “Configuring Disks” (page 70)

Updated information under Section : “Configuring Disk Cache” (page 87)Chapter 6: “Configuring Disks” (page 70)

Added a note to AUDITTRAILBUFFER description under “Attribute

Descriptions for Disk Commands” (page 198).

Chapter 14: “Storage Subsystem

Commands” (page 190)