SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

ChangeChapter
“INFO DISK Command” (page 254)
“INFO CLIM Command” (page 253)
“STATUS CLIM Command” (page 280)
• Under the ADD DISK command, changed heading from Disk Attribute
Descriptions to “Attribute Descriptions for Disk Commands” (page 198),
and added statements under disk commands referring to this section.
• Added information to the WRITECACHE attribute under “Attribute
Descriptions for Disk Commands” (page 198).
• Added example of how to create an obey file from which attributes can
be replicated from one disk to another under “ADD DISK Examples for
Physical Disks” (page 196). This example includes disk partitioning and
write caching.
• Added PRIMARYPARTITION, MIRRORPARTITION, SENDTO STORAGE,
PRIMARYCLIM, MIRRORCLIM, BACKUPCLIM, and MBACKUPCLIM
attributes to “Disk Attributes for the ADD Command” (page 195).
• Added PRIMARYPARTITION, MIRRORPARTITION, NOSTART, and
SENDTO STORAGE to “Disk Attributes for the ALTER DISK Command”
(page 230).
• Added description for the ALTER DISK attribute, NOSTART, to “Attribute
Descriptions for Disk Commands” (page 198) and the “ALTER DISK
Command” (page 228).
• Added descriptions for the ALTER DISK attributes and the ADD DISK
attributes, PRIMARYPARTITION, MIRRORPARTITION, and SENDTO
STORAGE, to “Attribute Descriptions for Disk Commands” (page 198),
“ALTER DISK Command” (page 228), and “ADD DISK Command”
(page 194).
• Changed the “Attribute Descriptions for Disk Commands” (page 198) to
indicate that if you do not configure a value for AUDITTRAILBUFFER, or
if the value you specify is less than 2, DP2 uses a value of 128.
• Changed the “Attribute Descriptions for Disk Commands” (page 198) to
indicate that the SERIALWRITES attribute cannot be enabled for
BladeSystems' disk subsystems attached with CLIMs because DP2 uses
parallel writes for better performance. Serial writes are not needed
because the CLIM is fully buffered.
• Added a detailed example for the INFO CLIM Command under “INFO
CLIM Examples” (page 254).
• Changed the example about how to display encrypted devices that use
a CLIM under “STATUS CLIM Examples” (page 281).
• Changed the example about how to display consistency information about
a disk volume under “STATUS DISK Examples For Physical Disks”
(page 283).
• Added the BUFFERING attribute to the “ADD TAPE Attributes” (page 226)
and “ALTER TAPE Attributes” (page 242). Added a buffering example for
the ALTER TAPE command under “ALTER TAPE Examples” (page 244).
• Added notes about security officer involvement for the CLEARENCRYPTKEY,
NEWENCRYPTKEY, and KEYGENPOLICY attributes in these sections:
◦ Section : “Attribute Descriptions for Disk Commands” (page 198)
◦ Section : “ALTER TAPE Attributes” (page 242)
◦ Section : “INITIALIZE DISK Command” (page 260)
◦ Section : “Managing Encrypted Disk Drives” (page 116)
Appendix B: “Upgrade and Replacement
Procedures” (page 362)
16