SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

DISK $disk
is the name of the disk.
SENDTO STORAGE
directs the command to the storage subsystem. This attribute is required unless you specified
SENDTO STORAGE in a previous ASSUME command.
LIKE object
identifies an existing object whose attribute values are copied to the object affected by this
command. The object name must currently exist in the system configuration, and the object
type must match that of the object affected by this command. If you specify LIKE, any attribute
values that you explicitly specify override the attribute values of the LIKE object.
The location, SAC, and device ID values are not copied from the LIKE object. To assign values
to these attributes, you must explicitly specify them.
attribute-spec
is one or more of:
• “Disk Attributes for the ADD Command” (page 195)
• “Virtual Disk Attributes for the ADD Command” (page 196)
Disk Attributes for the ADD Command
These attributes are valid for the ADD DISK command. For a description of these attributes, see
“Attribute Descriptions for Disk Commands” (page 198)
[ , AUDITTRAILBUFFER number ]
[ , AUTOREVIVE { ON | OFF } ]
[ , AUTOSELECT { ON | OFF } ]
[ , AUTOSTART { ON | OFF } ]
[ , BACKUPCLIM clim-name
[ , BACKUPCPU number ]
[ , BACKUPDEVICEID { number | ( shelf, bay ) }]
[ , BACKUPLOCATION {group,module,slot) ]
[ , BACKUPPORTNAME number ]
[ , BACKUPSAC { number | name } ]
[ , CAPACITYMISMATCH { ON | OFF } ]
[ , CBPOOLLEN number ]
[ , FASTBULKWRITE { ON | OFF } ]
[ , FORCED ]
[ , FSTCACHING { ON | OFF | ENABLED} ]
[ , FULLCHECKPOINTS { DISABLED | ENABLED | FORCED } ]
[ , HALTONERROR number ]
[ , HIGHPIN { ON | OFF } ]
[ , LKIDLONGPOOLLEN number ]
[ , LKTABLESPACELEN number ]
[ , MAXLOCKSPEROCB number ]
[ , MAXLOCKSPERTCB number ]
[ , MBACKUPCLIM clim-name
[ , MBACKUPDEVICEID { number | ( shelf, bay ) } ]
[ , MBACKUPLOCATION {group,module,slot) ]
[ , MBACKUPPORTNAME number ]
[ , MBACKUPSAC { number | name } ]
[ , MIRRORCLIM clim-name
[ , MIRRORDEVICEID { number | ( shelf,bay ) } ]
[ , MIRRORLOCATION ( group,module,slot ) ]
[ , MIRRORLUN number ]
[ , MIRRORPARTITION mirror-part-num
[ , MIRRORPORTNAME number ]
[ , MIRRORSAC { number | name } ]
[ , NONAUDITEDINSERT { ON | OFF } ]
[ , NUMDISKPROCESSES number ]
[ , OSSCACHING { ON | OFF } ]
ADD Command 195