SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

AUTOSELECT { ON | OFF }
specifies whether a virtual disk process is allowed to automatically consider this physical volume
when making file-placement decisions. This attribute is valid only when this physical volume is
a member of a storage pool
Enable automatic selection (default).ON
Disable automatic selection.OFF
AUTOSTART { ON | OFF }
(internal and M8xxx disks only) specifies whether to automatically start the disk process when
the disk is inserted.
Enable automatic starting (default).ON
Disable automatic starting.OFF
DISK AUTOSTART ON is ignored if SUBSYS AUTOSTART is OFF.
For information about using this attribute, see “Mirrored Disk Placement” (page 77).
BACKUPCLIM clim-name
is the name of the CLIM that controls the backup path to the disk.
NOTE: This attribute is not valid for the PROFILE object.
BACKUPCPU number
is the processor in which the backup IOP starts
NOTE: This attribute is not valid for the PROFILE object.
The process must be in the STOPPED state or not running for you to alter this attribute.
BACKUPDEVICEID { number | ( shelf, bay ) }
(45xx and M8xxx Fibre Channel disks only) is the device ID of the disk accessed on the
backup path to the disk
NOTE: This attribute is not valid for the PROFILE object.
This attribute is optional. If specified, it must be the same device ID as that specified for
PRIMARYDEVICEID.
For 45xx disks:
is the unit number of the disk. number is in the range 1 through 7.number
For M8xxx Fibre Channel disks:
is the Fibre Channel disk module (FCDM) shelf number. shelf is in the range 1 through 4.shelf
is the number of the disk. bay is in the range 1 through 14.bay
If you configure a disk volume for use with an FCSA connected to an ESS, you cannot specify
BACKUPDEVICEID.
BACKUPLOCATION ( group, module, slot )
(45xx and M8xxx disks only) is the location of the adapter that controls the backup path to
the device
200 Storage Subsystem Commands