SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

PHYSVOLSELECT { ON | OFF }
specifies whether a virtual disk process can consider this physical volume for file placement.
This attribute is valid only when this physical volume is a member of a storage pool
A virtual disk process can consider this physical volume for file placement (default).ON
A virtual disk process cannot consider this physical volume for file placement, regardless of the
information supplied in a command. If PHYSVOLSELECT is OFF, the value of AUTOSELECTis ignored.
OFF
POOL $pool
(for virtual disks) is the name of the storage pool process associated with the virtual disk.
NOTE: This attribute is required when adding virtual disks. It has no default and it cannot be
used with the ALTER DISK command.
The storage pool process must be in the STARTED state. In addition, the CATALOGLOCATION
volume of that storage pool process must be in the STARTED state and enabled in TMF.
POOL { $pool | EXCLUDE }
(for physical disks and profiles) specifies whether a physical volume is a member of a specified
storage pool
is the name of the storage pool to which the physical volume is being added.$pool
removes a physical volume from a storage pool.EXCLUDE
See “Configuring and Managing Storage Pools for Disks” (page 134).
PRIMARYCLIM clim-name
is the name of the CLIM that controls the primary path to the disk.
NOTE: This attribute is not valid for the PROFILE object.
PRIMARYCPU number
is the processor in which the primary IOP starts.
NOTE: This attribute is not valid for the PROFILE object.
The process must be in the STOPPED state or not running for you to alter this attribute.
PRIMARYDEVICEID { number | ( shelf,bay) }
(45xx and M8xxx disks only) is the device ID of either a nonmirrored disk or of the primary
disk of a mirrored volume
NOTE: This attribute is not valid for the PROFILE object.
For 45xx disks:
Is the unit number of the disk. number is in the range 1 through 7.number
For M8xxx disks in an FCDM:
Is the FCDM’s shelf number. shelf is in the range 1 through 4.shelf
Is the number of the disk. bay is in the range 1 through 14.bay
If you configure a disk volume for use with an FCSA connected to an ESS, you cannot specify
PRIMARYDEVICEID.
210 Storage Subsystem Commands