SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

ADD [ / OUT file-spec / ] SCSI $SCSI-device
, SENDTO STORAGE [ , LIKE object ]
[ , attribute-spec ]...
Wild-card characters are not supported.
OUT file-spec
directs all SCF output to the specified file.
SCSI $SCSI-device
is the name of the Open SCSI device.
SENDTO STORAGE
directs the command to the storage subsystem. This attribute is required unless you specified
SENDTO STORAGE in a previous ASSUME command.
LIKE object
identifies an existing object whose attribute values are copied to the object affected by this
command. The object name must currently exist in the system configuration, and the object
type must match that of the object affected by this command. If you specify LIKE, any attribute
values that you explicitly specify override the attribute values of the LIKE object.
The location, SAC, and device ID values are not copied from the LIKE object. To assign values
to these attributes, you must explicitly specify them.
attribute-spec
is one or more “ADD SCSI Attributes”.
ADD SCSI Attributes
[ , BACKUPCPU number ]
[ , BACKUPLOCATION ( group,module,slot ) ]
[ , BACKUPPORTNAME number ]
[ , BACKUPSAC number | name ]
[ , HIGHPIN { ON | OFF } ]
[ , LUN number ]
[ , MAXOPENS number ]
[ , NUMIO number ]
[ , PRIMARYCPU number ]
[ , PRIMARYLOCATION ( group,module,slot ) ]
[ , PRIMARYPORTNAME number ]
[ , PRIMARYSAC number | name ]
[ , PROGRAM [[$vol.]subvol.]fileid ]
[ , RECSIZE number ]
[ , SCSIID number ]
[ , STARTSTATE { STARTED | STOPPED } ]
[ , STRUCTAREASIZE number ]
[ , TRACEBUFLEN number ]
[ , TRACELEVEL number ]
BACKUPCPU number
is the processor in which the backup IOP starts. If not specified, the processor is automatically
chosen based on the current, primary-adapter, processor-access list. The first entry in the
processor-access list becomes the primary processor and the second entry becomes the backup
processor.
BACKUPLOCATION ( group,module,slot )
is the location of the adapter that controls the backup path to the device. This attribute has no
default value. If this attribute is not specified, the device is not accessible through its backup
path.
ADD Command 223