SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

-> INFO $ZZSTO.#INTERNAL-DISK-3
• To display information about all disk profiles on the system:
-> INFO PROFILE $ZZSTO.*
INFO SCSI Command
The INFO SCSI command displays configuration information about an Open SCSI device. The
command syntax is:
INFO [ / OUT file-spec / ] SCSI $SCSI-device
[ , { DETAIL | OBEYFORM } ] [ , SEL state ]
Wild-card characters are supported.
SCSI $SCSI-device
is the name of the Open SCSI device.
DETAIL
displays detailed configuration information.
OBEYFORM
displays information about the object in the format used in an ADD command.
SEL state
specifies that the command affects only devices in the specified state.
INFO SCSI Examples
• To display information about an Open SCSI device:
-> INFO $DEV0
See the display and explanation under “Example of an INFO SCSI Report” (page 171).
• To display detailed information about an Open SCSI device:
-> INFO $DEV5, DETAIL
See the display and explanation under“Examples of Detailed INFO SCSI Reports” (page 171)
.
INFO SUBSYS Command
The INFO SUBSYS command displays configuration information about the $ZZSTO storage
subsystem manager. The command syntax is:
INFO [ / OUT file-spec / ] SUBSYS $ZZSTO
Wild-card characters are not supported.
SUBSYS $ZZSTO
is the storage subsystem manager.
INFO SUBSYS Consideration
The information showed by INFO SUBSYS and STATUS SUBSYS should always be the same. If
the information shown in these displays differs, contact your service provider.
INFO SUBSYS Example
-> INFO SUBSYS $ZZSTO
See the display and explanation under “Using the Storage Subsystem Manager” (page 40).
INFO Command 259