SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

FORCED
terminates the IOP.
SEL state
specifies that the command affects only devices in the specified state.
RESET MON Consideration
The RESET command is ignored if the process is started.
RESET MON Example
See the procedure for “Resetting the SMF Master Process” (page 47).
To terminate the SMF master process:
-> RESET $ZSMS, FORCED
RESET POOL Command
The RESET POOL command puts a storage pool process into the STOPPED state, substate DOWN,
ready for restarting. The syntax is:
RESET [ / OUT file-spec / ] POOL $pool
[ , FORCED ] [ , SEL state ]
Wild-card characters are supported.
OUT file-spec
directs all SCF output to the specified file.
POOL $pool
is the storage pool process.
FORCED
terminates the IOP.
SEL state
specifies that the command affects only devices in the specified state.
RESET POOL Consideration
The RESET command is ignored if the process is started.
RESET POOL Example
See the procedure for “Resetting a Storage Pool” (page 142).
To terminate the storage pool process:
-> RESET $POOL00, FORCED
RESET SCSI Command
The RESET SCSI command puts an Open SCSI device into the STOPPED state, substate DOWN,
ready for restarting. The syntax is:
RESET [ / OUT file-spec / ] SCSI $SCSI-device
[ , FORCED ] [ , SEL state ]
Wild-card characters are supported.
OUT file-spec
directs all SCF output to the specified file.
272 Storage Subsystem Commands