SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

FORCED specifies that the command be executed without any interaction with the user.
STATS SAC Examples
• To obtain statistics for SAC 1 on the FCSA in slot 3, module 3 of group 111:
-> STATS SAC $ZZSTO.#FCSA.SAC-1.GRP-111.MOD-3.SLOT-3
STORAGE - Stats SAC \IO.$ZZSTO.#FCSA.SAC-1.GRP-111.MOD-3.SLOT-3
Command timeouts........ 0 Device Changes......... 9
Fabric Device Changes... 0 FC Length Errors....... 0
ISP Database Changes.... 1 ISP Downloads.......... 1
ISP Fabric LID Available 126 ISP Firmware Errors.... 0
ISP Hardware Errors..... 0 ISP LIP Events......... 1
LIP Errors Reported..... 1 LIP Requests initiated. 0
LIP Reset Requests...... 0 Loop Down.............. 0
Loop Up................. 1 Non-specific Asyncs.... 0
Port WWN Changes........ 0 Successful Host Logins. 9
Unsuccessful Host Logins 0
• To obtain statistics for the port with worldwide name 2200000C50278562 connected to
SAC 2:
-> STATS SAC $ZZSTO.#FCSA.SAC-2.GRP-111.MOD-2.SLOT-2, &
-> PORTNAME 2200000C50278562
STORAGE - Port Stats SAC \IO.$ZZSTO.#FCSA.SAC-2.GRP-111.MOD-2.SLOT-2
Port Name......... 2200000C50278562
Invalid CRC............ 1144011040 Invalid Transmissions.. 608846415
Link Failure........... 1359347712 Loss of Signal......... 49358809
Loss of Sync........... 0 Sequence Protocol Error 3336992670
STATUS Command
The STATUS command displays current status information about an object.
Supported objects are:
• “STATUS ADAPTER Command” (page 279)
• “STATUS CLIM Command” (page 280)
• “STATUS DISK Command” (page 282)
• “STATUS MON Command” (page 284)
• “STATUS POOL Command” (page 285)
• “STATUS SAC Command” (page 285)
• “STATUS SCSI Command” (page 288)
• “STATUS SUBSYS Command” (page 288)
• “STATUS TAPE Command” (page 289)
STATUS ADAPTER Command
The STATUS ADAPTER command displays current information about a ServerNet adapter. The
syntax is:
STATUS [ / OUT file-spec / ]
ADAPTER $ZZSTO.#type.GRP-g.MOD-m.SLOT-s
[ , { DETAIL | FIRMWARE | SACS | SERVERNET | VPROCS } ]
Wild-card characters are supported.
STATUS Command 279