SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

00002E 2100000C504CFB71 2000000C504CFB71 Loop Login 00
First 64 bytes of Symbolic Name:
0000000000000000 0000000000000000 0000000000000000 0000000000000000
0000000000000000 0000000000000000 0000000000000000 0000000000000000
PortId Port Name Node Name Connection ADT State COS
000032 2100000C504CFCA9 2000000C504CFCA9 Loop Login 00
First 64 bytes of Symbolic Name:
0000000000000000 0000000000000000 0000000000000000 0000000000000000
0000000000000000 0000000000000000 0000000000000000 0000000000000000
PortId Port Name Node Name Connection ADT State COS
000033 2100000C504CFD6B 2000000C504CFD6B Loop Login 00
First 64 bytes of Symbolic Name:
0000000000000000 0000000000000000 0000000000000000 0000000000000000
0000000000000000 0000000000000000 0000000000000000 0000000000000000
STATUS SCSI Command
The STATUS SCSI command displays current status information about Open SCSI devices. The
syntax is:
STATUS [ / OUT file-spec / ] SCSI $SCSI-device[-P |-B ]
[ , DETAIL ] [ , SEL state ]
Wild-card characters are supported.
OUT file-spec
directs all SCF output to the specified file.
SCSI $SCSI-device [-P |-B ]
is the name of the Open SCSI IOP and, optionally, the path (primary or backup).
DETAIL
displays detailed status information.
SEL state
specifies that the command affects only devices in the specified state.
STATUS SCSI Examples
• To display the status of all Open SCSI devices on the system:
-> STATUS SCSI $*
• To display the status of an Open SCSI device:
-> STATUS $DEV0
See the display and explanation under “Example of a STATUS SCSI Report” (page 173).
• To display detailed status of an Open SCSI device:
-> STATUS $DEV00, DETAIL
See the display and explanation under “Example of a STATUS SCSI Report” (page 173).
STATUS SUBSYS Command
This subsection describes the STATUS SUBSYS command. The command syntax is:
STATUS [ / OUT file-spec / ] SUBSYS $ZZSTO [ , DETAIL ]
Wild-card characters are supported.
288 Storage Subsystem Commands