SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

Cause
All the paths to the given device can be down as a result of:
• A hardware error
• The operator stopping the device
• The device being serviced
Effect
The command is not executed.
Recovery
1. Verify the state of the device using the SCF STATUS command.
2. If needed, use the SCF RESET command to change the state of the device before retrying
the operation.
00010
STORAGE 00010 Negative response received from Storage Subsystem Manager.
Cause
The command was rejected by the storage subsystem manager process ($ZZSTO). This situation
might be caused by mismatched versions of the storage subsystem manager process and SCF.
Effect
The command is not executed.
Recovery
Check product versions with the SCF VERSION command and install the correct software, if
necessary.
00011
STORAGE 00011 Not supported by the down-version system (vernum).
vernum
is the version number of the down-version system.
Cause
The command was rejected by the storage subsystem manager process ($ZZSTO) because the
information requested by the command cannot be obtained from an older system.
Effect
The command is not executed.
Recovery
To resolve the version mismatch, contact your service provider.
00012
STORAGE 00012 Wrong state for objtype devname, state: state
objtype
is the object type of the object you specified with the command.
devname
is the name of the device you specified in the command.
state
is the current state of the device you specified in the command.
Cause
The device is in a state that prevents it from performing the operation requested. This error can
occur when you perform online as well as offline re-configuration. You cannot perform an online
reconfiguration of a mirror drive while TSM ($ZTSM) is running.
Storage Subsystem Error Messages 301