SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

cmd
is the command you specified.
sacpath
is the path of the ServerNet addressable controller (SAC) specified in the command.
Cause
You attempted to configure a SAC for a device that the SAC does not support.
Effect
The command is not executed.
Recovery
Resolve the cause of the failure and reissue the command.
00064
STORAGE 00064 cmd failed. No CRU info; cru-info error: errnum
cmd
is the command you specified.
cru-info
is additional information about the CRU in the command you specified.
errnum
is the error associated with this failure.
Cause
While trying to complete the requested command, communication with the CRU was interrupted.
Effect
The command is not executed.
Recovery
Verify the hardware is actually present and connected correctly. If the problem persists, contact
your service provider. See “If You Have to Contact Your Service Provider” (page 298).
00065
STORAGE 00065 cmd failed. No SAC present in sacpath.
cmd
is the command you specified.
sacpath
is the path of the ServerNet addressable controller (SAC) specified in the command.
Cause
You might have issued a command with an invalid SAC location. There is no SAC in the specified
location.
Effect
The command is not executed.
Recovery
Verify the hardware is actually present and connected correctly. If the problem persists, contact
your service provider. See “If You Have to Contact Your Service Provider” (page 298).
00066
STORAGE 00066 cmd failed. POST did not succeed for sacpath.
cmd
is the command you specified.
sacpath
is the path of the ServerNet addressable controller (SAC) specified in the command.
Storage Subsystem Error Messages 315