SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

2. Retry the command.
3. If the problem persists, contact your service provider. See “If You Have to Contact Your
Service Provider” (page 298).
00085
STORAGE 00085 REPLACE DISK volname Filesystem error returned from DSC_OLR_DEVICE_, error: err-num.
volname
is the disk name you specified.
err-num
is the file-system error that occurred. For more information, refer to the Guardian Procedure
Errors and Messages Manual.
Cause
A file-system error was returned from DSC_OLR_DEVICE_.
Effect
The command fails, possibly with the replace operation half finished.
Recovery
1. Refer to the error message for the cause of the error.
2. Retry the command.
3. If the problem persists, contact your service provider. See “If You Have to Contact Your
Service Provider” (page 298).
00086
STORAGE 00086 DISK volname does not have a software replacement record.
volname
is the disk name you specified.
Cause
No replace operation has been done for this object.
Effect
The command is not executed.
Recovery
This is an informational message only. No recovery action is needed.
00087
STORAGE 00087 DISK volname cannot have IOP object on itself.
volname
is the disk name you specified.
Cause
You attempted to run a disk IOP from an object file that resides on the disk controlled by that
IOP.
Effect
The command is not executed.
Recovery
Run the disk IOP from an object file that is not located on the disk controlled by that IOP.
In addition, ensure that:
• There are no crosswise configurations in your system.
• Executable objects are not placed on disks that start after the target disk starts.
The exception to this rule is the system-load volume, which can have its object file on its disk.
Storage Subsystem Error Messages 321