SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

Cause
The process cannot be terminated. An OSL process cannot be terminated while it has paths in
STARTED state.
Effect
The command is not executed.
Recovery
Verify the state of the paths using the STATUS command. If needed, use the STOP or ABORT
command to change the state of the paths before retrying the operation.
00100
STORAGE E00100 Command failed. Too many devices configured on a SAC
Cause
Too many devices configured on a SAC or too many IOPs in the same processor configured to
use an adapter.
Effect
The command is not executed.
Recovery
Configure fewer devices on the SAC or configure the IOP in different processors.
00101
STORAGE E00101 Attribute value conflicts with device location.
Cause
The specified attribute value conflicts with the device location.
Effect
The command is not executed.
Recovery
Specify attribute values and device location which are consistent with each other.
00102
STORAGE E00102 Requested operation failed due to a file system error.
Cause
Requested operation failed due to a file system error.
Effect
The command is not executed.
Recovery
Check the returned file system error to determine what to do next.
00103
STORAGE E00103 Command rejected because there's another action pending for the specified object name.
Cause
An action is currently in progress for the object name you specified.
Effect
The command is rejected.
Recovery
Wait a few seconds and try the command again.
00104
STORAGE E00104 Not allowed: the specified action is invalid for the specified disk volume
Storage Subsystem Error Messages 325