SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

Cause
C I/O library error during communication with CLIM.
Effect
The command is not executed.
Recovery
Make sure $ZZSTO can read and write in the $SYSTEM.ZZSTO subvolume.
00122
STORAGE E00122 Can't determine IP address for CLIM.
Cause
Can't determine IP address for CLIM.
Effect
The command is not executed.
Recovery
Make sure that STATUS CLIM $ZZCIP.clim-name shows the CLIM in STARTED state and that
INFO CLIM $ZZCIP.clim-name, DETAIL shows a Maintenance Interface IP address.
00123
STORAGE E00123 Can't run lunmgr on the CLIM.
Cause
Can't run lunmgr on the CLIM.
Effect
The command is not executed.
Recovery
1. Make sure the CLIM is running and connected.
2. Make sure SSH can communicate with the CLIM.
3. Make sure lunmgr is installed on the CLIM.
4. Run any CLIMCMD command manually for the same CLIM, which may also help to resolve
this issue. If any error is reported by CLIMCMD, correct this problem and re-issue the
command.
-> CLIMCMD S1002531 pwd
00124
STORAGE E00124 This command must target a device on the local system.
Cause
This command must target a device on the local system.
Effect
The command is not executed.
Recovery
Log on to the same system as the targeted device.
00125
STORAGE E00125 This command requires a member of the SECURITY-ENCRYPTION-ADMIN group.
Cause
This command requires a member of the SECURITY-ENCRYPTION-ADMIN group.
Effect
The command is not executed.
Storage Subsystem Error Messages 329