SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

01004
STORAGE 01004 command rejected, disk contains active audit trail files.
command
is the SCF command that you issued.
Cause
The command you issued is not allowed for a disk that contains active audit trail files.
Effect
The command is not executed.
Recovery
1. Verify you issued the command for the correct disk.
2. If you issued the command for the correct disk, you must stop the Transaction Management
Facility (TMF) subsystem and then reissue the command.
01005
STORAGE 01005 command rejected, disk is TMF protected.
command
is the SCF command that you issued.
Cause
The command you issued is not allowed for a disk that is protected by the TMF subsystem.
Effect
The command is not executed.
Recovery
1. Verify you issued the command for the correct disk.
2. Verify the state of the disk within the TMF subsystem. If needed, change the device's state
in the TMF subsystem before retrying the operation. Refer to the TMF Operations and
Recovery Guide for additional information.
01006
STORAGE 01006 Invalid disk path specified: diskpath.
diskpath
is the disk path that you specified in the command.
Cause
You specified a disk path that does not exist.
Effect
The command is not executed.
Recovery
Determine the correct disk path and reissue the command.
01007
STORAGE 01007 The command will make all paths to volname inaccessible.
command
is the SCF command that you issued.
volname
is the name of the volume that you specified in the command.
Cause
You issued a command that would make all paths to the disk inaccessible. This message is
generated by SCF only in noninteractive mode. In interactive mode, a prompt is generated
asking you to verify the command.
Storage Subsystem Error Messages 335