SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

Effect
The system configuration database is updated with the new name.
Recovery
Informational message only; no corrective action is required.
01034
STORAGE 01034 Resuming suspended disk revive on devname.
devname
is the name of the device you specified in the command.
Cause
The disk revive operation was restarted in response to an SCF START DISK command.
Effect
The revive operation continues from the point where it was suspended.
Recovery
Informational message only; no corrective action is required.
01035
STORAGE 01035 cmd failed. Invalid attribute value in: attribute.
cmd
is the SCF command you specified.
attribute
is the attribute that you specified with an invalid value.
Cause
You specified an invalid value for the attribute in the command.
Effect
The command is not executed.
Recovery
Determine the correct value for the attribute and reissue the command.
01036
STORAGE 01036 Disk pair is not consistent. The devname diskhalf not restarted.
devname
is the name of the device you specified in the command.
Cause
The modification time stamps on the primary and mirror disks of the mirrored volume differ. A
revive operation is required.
Effect
The command is executed. However, the disk half with the older time stamp is left in a STOPPED
summary state, substate DOWN.
Recovery
Use the SCF DISK START command to revive the volume.
01037
STORAGE 01037 Disk is not formatted. The revive is not started.
Cause
A revive operation is not started because the target disk is not formatted.
Effect
The command is not executed.
Storage Subsystem Error Messages 343