SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

command
is the SCF command that you issued.
devname
is the name of the device you specified in the command.
attribute
is the attribute that you specified with an invalid value.
Cause
You attempted to decrease the value of an attribute while the I/O process is in a STARTED state.
Effect
The command is not executed.
Recovery
Either:
• Correct the value for the indicated attribute.
• Place the I/O process in a STOPPED state and reissue the command.
01056
STORAGE W01056 The primary and mirror paths to a device should be on different chains.
Cause
You specified primary and mirror paths to a device on the same chain. This configuration is not
recommended.
Effect
The command is executed. This is a warning.
Recovery
Specify the two paths on different chains.
01057
STORAGE W01057 All configuration changes except those related to the mirror configuration
have been performed for the disk volume.
Cause
You requested changes to mirror-related configuration attributes of a disk volume that is in a
started state.
Effect
All configuration attributes that are not related to the mirror configuration of the disk volume has
been completed.
Recovery
None. A subsequent message will inform you about the effect of the action and ask you whether
to continue.
01058
STORAGE W01058 This action will cause the device to be inaccessible to the system.
Cause
You are about to power off a storage device.
Effect
The storage device will be powered off and will not be accessible for informational commands
such as the STATUS command.
Recovery
Respond “Y” to the prompt requesting approval to do changes online. If you do not want to
power off the storage device, enter "N" to the prompt.
348 Storage Subsystem Error Messages