SCF Reference Manual for the Storage Subsystem (G06.28+, H06.05+, J06.03+)

The INFO DETAIL,and INFO CONFIG reports start with this display.
Explanation of Fields — INFO SYSTEM Report
Indicates an attribute whose value you can change by using the ALTER DISK command.*
The processor number of the backup disk process.BackupCpu
Shows whether the disk process can run at a high PIN (ON) or must run at a low PIN (OFF). The
PIN is the process identification number.
HighPin
The processor number of the primary disk process.PrimaryCpu
The object file name of the disk process.Program
Shows whether the disk process is configured to be STARTED (in the STARTED state) or STOPPED
(in the STOPPED state, substate DOWN) when the system is loaded.
StartState
Displaying Disk Configuration Information
-> INFO $SYSTEM, CONFIG
Disk Type Specific Information:
*AuditTrailBuffer/SQLMXBuffer (MB)..... 0
*AutoRevive............................ OFF
*AutoSelect............................ n/a
*AutoStart............................. ON
*CapacityMismatch...................... OFF
*CBPoolLen............................. 1000
*FastBulkWrite......................... ON
*FSTCaching............................ OFF
*FullCheckpoints....................... ENABLED
*HaltOnError........................... 1
*LKIDLongPoolLen....................... 8
*LKTableSpaceLen....................... 15
*MaxLocksPerOCB........................ 5000
*MaxLocksPerTCB........................ 5000
*NonAuditedInsert...................... OFF
*NumDiskProcesses...................... 6
*OSSCaching............................ ON
*PhysvolSelect......................... n/a
*Pool.................................. None
*ProtectDirectory...................... SERIAL
*RecoveryTimeout....................... 30
*ReviveBlocks.......................... 1
*ReviveInterval........................ 100
*RevivePriority........................ 0
*ReviveRate............................ 0
*SerialWrites.......................... ENABLED
*WriteCache............................ DISABLED
Primary Path Information:
Adapter............................... $ZZSTO.#PMF.GRP-1.MOD-1.SLOT-50
Disk Device ID / Port Name............ 0
Disk Device LUN....................... 0
Location (Group,Module,Slot).......... (1,1,11)
SAC Name.............................. $ZZSTO.#PMF.SAC-2.GRP-1.MOD-1.SLOT-50
SAC Number............................ 2
Backup Path Information:
Adapter............................... $ZZSTO.#PMF.GRP-1.MOD-1.SLOT-55
Disk Device ID / Port Name............ 0
Disk Device LUN....................... 0
Location (Group,Module,Slot).......... (1,1,11)
SAC Name.............................. $ZZSTO.#PMF.SAC-2.GRP-1.MOD-1.SLOT-55
SAC Number............................ 2
Mirror Path Information:
Adapter............................... $ZZSTO.#PMF.GRP-1.MOD-1.SLOT-55
Disk Device ID / Port Name.............0
Disk Device LUN....................... 0
50 Displaying Information About Disk Drives