SCSI Extender Installation and User's Guide

Subsystem Control Facility (SCF) Configuration
SCSI Extender Installation and User’s Guide—522347-002
5-2
Configure the Storage Devices
This example adds a Fiber-to-SCSI extender (CTFSE) named $FSROUT1 to the
system configuration database:
-> ADD SCSI $FSROUT1,SENDTO STORAGE,PRIMARY LOCATION
(1,1,52),PRIMARYSAC 2,PRIMARYCPU 0,BACKUPCPU 1,SCSIID 9
In this example:
•
The $FSROUT1 is an example; however, you can use any device name.
•
The SENDTO STORAGE attribute specifies the subsystem in which to install
the SCSI extender.
•
The PRIMARY LOCATION attribute specifies the location (group, module, and
slot) of the CRU (adapter) to which the SCSI extender is attached.
•
The PRIMARYSAC attribute is necessary when using ServerNet/DA with an
S-SAC.
•
The PRIMARYCPU attribute specifies the primary processor.
•
The BACKUPCPU attribute specifies the backup processor.
Configure the Storage Devices
A tape drive connected to a SCSI extender must be configured as ID 5. Use DEVICEID
attribute 5 when adding the tape drive to the system configuration database.
A tape library connected to a SCSI extender must be configured as ID 3.
Refer to the SCF Reference Manual for the Storage Subsystem for more information
about configuring storage devices.
Note. The ID for a Fiber-to-SCSI extender (CTFSE) is preconfigured to 9 and must not be
changed.