SeeView Manual

Seedit Utility
HP NonStop SeeView Manual—526355-004
4-12
SUBVOLS
Examples
These examples demonstrate the SET command:
SUBVOLS
The SUBVOLS command displays the names of subvolumes on the specified system
and volume.
system
specifies a valid system name.
volume
specifies a valid volume name.
subvolume
specifies a valid subvolume name. Specifying a subvolume causes the display to
begin with subvolume rather than the first subvolume on the specified volume.
*
specifies all subvolumes.
Example
This example demonstrates the SUBVOLS command:
SYSTEM
The SYSTEM command sets and displays the current default system, if any. SYSTEM
without \system name sets the system back to the original system.
system-name
specifies a valid system name.
SET LOGFILE $SYSTEM.SYSTEM.OPRLOG
SET LOGFILE PATHLOG
SET MAXRECS 30
SET MAXWAIT 30
SUBVOLS [ [ \ system. ] [ $volume. ] [ subvolume | *] ]
SUBVOLS $SYSTEM { Display subvols on volume $system
SYSTEM [ \system-name ]