SeeView Server Gateway (SSG) Manual

System Setup (Pre-D48)

HP NonStop SeeView Server Gateway (SSG) Manual—526356-004

2-60

RSC Setup for SSG

Example 2-1 shows the contents of the RSCINI file that was generated when the

START RscSetup Build menu item was selected from the RscSetup menu.

Once you follow the steps to copy RSCINI to each workstation, as described earlier,

activate the section that applies to that workstation by removing the RSC semicolon

comment delimiter from the ;[RSC] section identifier that describes the RSC

configuration parameters for that workstation. For instance, in Example 2-1, the section

for Async terminal T22T0 would be activated by removing the semicolon from in front

of the [RSC] section identifier for that section (shown in bold type in the example).

Note. The RSCINI file contains a section for each RSC Line Configuration menu item defined

in the RSC Setup for SSG. You must activate the appropriate section in each workstation for

the desired communications method and transport address for that workstation.

Example 2-1. RSC.INI File Generated From Previous Examples (page 1 of 2)

; ----------------------------------------------------------------------

; -- RSC.INI configuration for CSG for Windows (built by SSGSETUP) --

; ----------------------------------------------------------------------

; - This file MUST be located in the CSG for Windows directory. -

; - -

; - It is very important that the names and options specified -

; - in this file be in sync with the file "SSGRSC" on the host. -

; - -

; - To insure synchronization, OBEY the file named "INSTALL" in -

; - the ZNOWSSG host software installation subvolume, and select the -

; - menu item "RSC Setup for SSG" following the steps in online Help. -

; - -

; - After you have configured your SSG lines, use the START RscSetup -

; - Build menu item to build a general RSC.INI file that can be used -

; - on each workstation that you have configured to communicate with -

; - SSG. -

; - -

; - Once the RSC.INI file is built, you should download it to each -

; - CSG workstation, and activate the [RSC] section pertaining to -

; - that workstation. (Delete the ";" comment character in front -

; - of the [RSC] section for that workstation). -

; ----------------------------------------------------------------------;