SeeView Server Gateway (SSG) Manual

System Setup (Pre-D48)
HP NonStop SeeView Server Gateway (SSG) Manual—526356-004
2-62
RSC Setup for SSG
Example 2-2 shows the contents of the SSGRSC file generated when the START
RscSetup Build menu item was selected from the RscSetup menu. The file SSGRSC is
referenced automatically when you use the SSG START GATEWAY command.
Example 2-2. SSGRSC File Generated From Previous Examples (page 1 of 2)
[----------------------------------------------------------------]
[ SSGRSC configuration for SSG for Windows (build by SSGSETUP) ]
[----------------------------------------------------------------]
[ ASY $T22.#T0 19200 1 7 1 EIA EVEN ]
[ NET $LAN1 #D2 DOMAIN SSGHOST SSGLN01 0 ]
[ TCP $ZTC0 TDPPORT01 8192 8192 138.252.41.255.1025 1 ]
[----------------------------------------------------------------]
[ This file is used by the SSG SeeView GATEWAY when the ]
[ SSG START GATEWAY command is executed. This file contains ]
[ all SSG related RSCCOM commands to configure the RSC TCP. ]
[----------------------------------------------------------------]
[ Note: The PATHSENDENABLE command is present so this file can ]
[ be used with old TDSCOM A10 versions of RSC. This file is ]
[ compatible with new C30 versions of RSCCOM, the warning 3007 ]
[ is informational only, and can safely be ignored. ]
[----------------------------------------------------------------]
maxerrors 99
pathSendEnable
[----------------------------------------------------------------]
[ Configure RSC TDP terminal(s) by using term template. ]
[ Note these parameters usually are NOT site dependent. ]
[----------------------------------------------------------------]
reset term
set term pwypathmon $ZSGY
set term pwytimeout 60
set term template YES
add term SSGTEMPL
[----------------------------------------------------------------]
[ RscCom AsyncPort TDP config (T22T0)
[ See RSC and SSG for Windows manuals for detailed information. ]
[----------------------------------------------------------------]
reset asyncport
set asyncport linename $T22.#T0
add asyncport T22T0
start asyncport T22T0
status asyncport T22T0