ServerNet Cluster 6770 Hardware Installation and Support Guide

Introduction to the ServerNet Cluster Switch (Model
6770)
ServerNet Cluster 6770 Hardware Installation and Support Guide—522544-002
1-6
ServerNet Cluster Switch Enclosure
•
AC Transfer Switch on page 1-10 provides dual power rails for the UPS and
ServerNet II Switch.
The ServerNet Cluster Switch is available in an enclosure or in an EIA standard rack-
mount (you must provide the rack).
ServerNet Cluster Switch Enclosure
When you receive a ServerNet Cluster Switch enclosure, the ServerNet II switch, AC
transfer switch, and UPS are already installed inside the enclosure. The power monitor
cables and power cords between the three components are already connected. You
can place a ServerNet Cluster Switch enclosure on the floor or stack it on top of a base
system enclosure. Other stacking arrangements are not supported.
Figure 1-5. Components in a ServerNet Cluster Switch Enclosure
VST013.vsd