ServerNet Cluster 6770 Hardware Installation and Support Guide

Planning for the ServerNet Cluster Switch
ServerNet Cluster 6770 Hardware Installation and Support Guide—522544-002
2-3
Planning to Install a ServerNet Cluster Switch
f. If you have more than one switch
per fabric, add the switch to an
existing ServerNet cluster.
ServerNet Cluster Manual
Add Switch guided configuration tool
(TSM)
Update Topology action of the ServerNet
Cluster Resource (OSM Service
Connection online help)
4. Plan to add nodes to a ServerNet
cluster.
ServerNet Cluster Manual
a. Install new NonStopNonStop
S-series servers, if not already
installed.
NonStop S-series Planning and
Configuration Guide
NonStop S-series Hardware Installation
Guide
b. Move any existing NonStop
S-series servers, if needed.
NonStop S-series Hardware Installation
Guide
c. Make sure you have all the
required software on each node.
Required Software on page 2-4
If you plan to connect a node running
software prior to the G06.14 release,
refer to the ServerNet Cluster Manual
and your service provider or more
information about any needed SPRs.
d. Install the required software on
each node, if not already
installed.
To install a software release, refer to the
G06.nn Software Installation and
Upgrade Guide.
To install SPRs, refer to the softdoc for
that SPR and Managing Software
Changes.
e. Update the SP firmware on each
node, if needed.
Service Processor (SP) Firmware on
page 2-7
OSM or TSM Online Help
Planning Task Documentation