ServerNet Cluster 6770 Hardware Installation and Support Guide

Contents

ServerNet Cluster 6770 Hardware Installation and Support Guide—522544-002

2. Planning for the ServerNet Cluster

Switch (continued)

2. Planning for the ServerNet Cluster Switch (continued)

Planning for Environmental Requirements 2-15

Planning for Power to the ServerNet Cluster Switch 2-16

AC Power Requirements 2-16

Planning to Respond to Power Failures 2-16

3. Preparing to Install or Replace 6770 ServerNet Cluster Switch

Components

Preparing to Install Switch Components 3-1

Preparing to Replace Switch Components 3-1

Verifying Software and Firmware 3-2

Verifying SP Firmware Version 3-2

Verifying the System Configuration 3-3

Verifying System Operations 3-4

Verifying System Enclosures 3-4

Verifying Processor Status 3-4

Verifying the Status of the Internal ServerNet Fabric 3-4

4. Installing a ServerNet Cluster Switch Enclosure

Stacking a ServerNet Cluster Switch Enclosure 4-1

Preinstalled Components and Cables 4-1

Installing the Enclosure 4-2

Task 1: Planning and Preparation 4-2

Task 2: Preparing the ServerNet Cluster Switch 4-2

Task 3: Completing the Installation 4-3

Configuring the ServerNet Cluster 4-3

5. Installing Switch Components in an EIA Standard Rack

Procedure Summary 5-2

Task 1: Assemble the Required Tools 5-3

Task 2: Verify That You Have All the Parts in the Rack-Mount Kit 5-3

Task 3: Install the Cage Nuts 5-4

Task 4: Install the Rails and Cable-Management Assembly 5-6

Task 4a: Install the UPS Rails 5-6

Task 4b: Install the Cable-Management Tray 5-6

Task 4c: Install the Cable-Management Assembly 5-7

Task 4d: Install the ServerNet II Switch Slide Rails 5-7

Task 5: Install the UPS 5-8

Task 6: Install the AC Transfer Switch 5-8