ServerNet Cluster 6770 Hardware Installation and Support Guide

Installing a ServerNet Cluster Switch Enclosure

ServerNet Cluster 6770 Hardware Installation and Support Guide—522544-002

4-2

Installing the Enclosure

Task 1: Planning and Preparation

1. Review Section 1, Introduction to the ServerNet Cluster Switch (Model 6770) for a

detailed description of the switch components, connections, cables, and cords.

2. Perform all the planning steps in Section 2, Planning for the ServerNet Cluster

Switch .

3. Perform all the planning steps in the ServerNet Cluster Manual.

4. Perform all steps in Section 3, Preparing to Install or Replace 6770 ServerNet

Cluster Switch Components.

5. Make sure that you have the following tools available:

•

T25 Torx screwdriver

•

Phillips screwdriver (might be needed)

6. Prepare the delivery route before a new ServerNet Cluster Switch enclosure

arrives:

•

Make sure that the paths and doorways are clear and wide enough for the

enclosures on their pallets, the packing crates, and the equipment used to

transport them.

•

Make sure that elevators can carry the weight of the crated system, the moving

equipment, and the movers. Each ServerNet Cluster Switch enclosure weighs

approximately 180 pounds.

7. Move the equipment on its shipping pallet into the room in which it will be installed.

Task 2: Preparing the ServerNet Cluster Switch

1. From the front of the enclosure, use a T25 Torx screwdriver to remove the four M5

Torx screws that attach the blank panels above the ServerNet II Switch. This allows

you to route the cables more easily onto the cable-management assembly.

2. Loosen the black thumb screws holding the ServerNet II Switch to the enclosure

frame. If the screws are too tight to loosen by hand, use a phillips screwdriver to

loosen the screws.

3. If there is a voltage setting on the AC/DC power supply located in the back of the

ServerNet II Switch, make sure that the voltage is set correctly. Set the

international version of the ServerNet Cluster Switch at 230 volts; set the Japanese

and North American ServerNet Cluster Switches at 115 volts.

4. Pull out the ServerNet II Switch on its rails until you hear the latches click.