ServerNet Cluster 6770 Hardware Installation and Support Guide

Connecting the ServerNet Fiber-Optic Cables
ServerNet Cluster 6770 Hardware Installation and Support Guide—522544-002
6-5
Routing and Connecting the Cables
3. Align the keys on the connector body with the key slots on the receptacle of the
ServerNet II Switch.
4. Insert the connector plug into the receptacle, squeezing the connector body gently
between your thumb and forefinger as you insert it. Push the connector plug
straight into the receptacle until the connector plug clicks into place.
5. Route the fiber-optic ServerNet cables onto the cable-management assembly and
fasten the Velcro ties. The bend radius for these fiber optic cables should be 45
mm (1.8 inches). Make sure to leave at least 3.5 inches between the cable-
management assembly arms.
Figure 6-3. Inspecting Fiber-Optic Cable Connectors
VST003.vsd