ServerNet Cluster 6780 Operations Guide (G06.24+, H06.03+)

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster 6780 Operations Guide—525606-002
5-31
STATUS SWITCH Command
STATUS SWITCH Command
The STATUS SWITCH command obtains status information for the cluster switches.
This information is returned by the external ServerNet SAN manager process
($ZZSMN). STATUS SWITCH is a nonsensitive command.
The STATUS SWITCH command syntax is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
FABRIC { X | Y } | ONLY { X | Y }
displays information for only the local switch on the specified fabric. ONLY and
FABRIC are synonymous in this case, and either can be used. The local switch is
the one directly connected to the node where you issue this command.
[ FABRIC { X | Y } , ] ZONE znum , LAYER lnum
a string of identifiers, used to specify the cluster switch for which you want status
information. It is used only in a ServerNet cluster built with 6780 switches.
FABRIC { X | Y } specifies the external ServerNet fabric.
ZONE znum specifies the cluster switch zone. znum must be in the range 1
through 3.
LAYER lnum specifies the cluster switch layer. lnum must be in the range 1
through 4.
CRU cnum
specifies a CRU slot number within a specified 6780 switch. If this optional
parameter is specified, only status information for the CRU in the specified slot is
displayed. cnum must be in the range 1 to 18. Table 5-3 lists the types of CRUs in
the slots of a 6780 switch.
STATUS [ / OUT file-spec / ] SWITCH $ZZSMN
[ , FABRIC { X | Y } | , ONLY { X | Y } ]
[ [ , FABRIC { X | Y } ] , ZONE znum , LAYER lnum ]
[ , CRU cnum ]
[ , ROUTER ]
[ , ROUTER rnum, [ PORT pnum ] ]
[ , SWITCHPORTS ]