ServerNet Cluster 6780 Operations Guide (G06.28+, H06.05+)

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster 6780 Operations Guide—525606-003
5-5
ALTER SWITCH Command
ALTER SWITCH Command
ALTER SWITCH is a sensitive command. It allows you to:
•
Assign or change a locator string for the cluster switch.
•
Make the LEDs on the switch blink or stop blinking.
•
Specify the fabric setting for 6770 switches.
The ALTER SWITCH command syntax is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
FABRIC { X | Y } | NEAREST { X | Y }
specifies the external ServerNet fabric of the local cluster switch you want to alter.
NEAREST and FABRIC are synonymous in this case, and either can be used.
The local switch is the one directly connected to the node where you issue this
command.
FABRIC { X | Y } , ZONE znum , LAYER lnum
is a string of identifiers used to specify the switch you want to alter. Used only in a
ServerNet cluster built with 6780 switches.
FABRIC { X | Y } specifies the external ServerNet fabric.
ZONE znum specifies the cluster switch zone. znum must be in the range 1
through 3.
LAYER lnum specifies the cluster switch layer. lnum must be in the range 1
through 4.
ALTER [ / OUT file-spec / ] SWITCH $ZZSMN
{ , FABRIC { X | Y } |, NEAREST { X | Y } }
{ , FABRIC { X | Y }, ZONE znum , LAYER lnum }
{ , BLINK { ALL | FAULTLEDS | NONE } }
{ , LOCATOR string }
{ , FABRICSETTING { X | Y | NONE } }