ServerNet Cluster 6780 Operations Guide (G06.28+, H06.05+)

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster 6780 Operations Guide—525606-003
5-12
INFO CONNECTION Command Example
CRU Slot
is the slot number of the switch PIC that contains the port for this node connection.
Valid Switch PIC slot numbers for node connections are 6, 7, 8, and 9.
CRU Port
is the port number (on the switch PIC) used for this node connection. Valid port
numbers are 1 or 2.
PIC Type (switch)
is the type of switch PIC used for this node connection.
Transceiver
identifies the type of transceiver used for the switch-to-node port.
Desired Port State
indicates whether transmit and receive are to be enabled. This attribute is valid
only for 6770 switches. Valid states are:
TX/RX Dsbld
indicates that transmit and receive are to be disabled. This value applies only
to the 6770 switch.
TX/RX Enbld
indicates that transmit and receive are to be enabled. This value applies only to
the 6770 switch.
TX/RX Auto
indicates that no low-level neighbor checks are run. The port can still enable or
disable ServerNet traffic. This value applies only to the 6770 switch.
UNKNOWN
indicates that the desired port state is not known.
n/a
indicates that his field does not apply to 6780 switches.
Neighbor ID Check
indicates the type of checks to be performed to enable the port. The type of
neighbor check depends on the type of port. For possible values, see Table 5-2,
Neighbor Checks.