ServerNet Cluster 6780 Operations Guide (G06.28+, H06.05+)

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster 6780 Operations Guide—525606-003
5-13
INFO SUBSYS Command
INFO SUBSYS Command
The INFO SUBSYS command displays values of configuration attributes for the SMN
subsystem. These values, stored in the System Configuration Database, specify the
distances between zones. You can use the ALTER SUBSYS command to alter the
values.
The INFO command syntax is:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
DETAIL
is acceptable in the syntax for this command but in this case does not cause
additional information to be displayed .
Considerations
•
Currently, INFO SUBSYS and INFO SUBSYS, DETAIL show the same information:
the time of the last ALTER SUBSYS command, and the distances between zones
in a three-zone long-haul configuration.
Table 5-2. Neighbor Checks
Type of Neighbor Check Description
No Query Assume Pass Performs no query of neighbor, assumes it passes, and
enables the port
No Query Assume Fail Performs no query of neighbor and assumes it fails.
Disables port by default.
Query Ignore Result Queries neighbor, ignores the result
Query Must Pass To Enable Port Queries neighbor and enables port only if it passes
Query No Resp Expected Queries neighbor, expecting no response. Used for
node ports.
INFO [ /OUT file-spec/ ] SUBSYS $ZZSMN [ , DETAIL ]