ServerNet Cluster 6780 Operations Guide (G06.28+, H06.05+)

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster 6780 Operations Guide—525606-003
5-16
Considerations
Considerations
•
Wild cards are not supported
•
The output of the INFO SWITCH command varies depending on the model of
switch.
•
When the X and Y switches are different models, you must specify only one of the
switches. To get information on both switches, issue one command for each fabric.
This situation occurs only during a migration to the layered topology.
•
In addition to the values described in the INFO command displays, you might see
values of N/A or UNKNOWN. In general, a value of N/A means that a value is not
applicable or not expected for the field. A value of UKNOWN means that a value is
expected but cannot be obtained for some reason.
•
VPROC strings that identify the versions of firmware, FPGA, and configuration are
truncated in the INFO SWITCH display. To see the full VPROC string, use the
OSM Service Connection.
INFO SWITCH Command Example
This example shows the INFO SWITCH $ZZSMN command:
INFO SWITCH $ZZSMN
|----------------------------------------------------------------------------|
| Response Status | ok | ok |
| Rsp Status Detail | No Status Detail | No Status Detail |
|--------------------|---------------------------|---------------------------|
| ServerNet Switch | Switch Information | Switch Information |
|--------------------|---------------------------|---------------------------|
| Switch Type | Model 6780 | Model 6780 |
| Switch Zone | 1 | 1 |
| Switch Layer | 2 | 2 |
| Group Number | 1010 | 1011 |
| Module Number | 2 | 2 |
| | | |
| Switch Locator | Room 211, East Wall | Room 211, South Wall |
| | | |
| Packetizer Type | ServerNet II | ServerNet II |
Table 5-3. CRU Slots for the 6780 Switch
Slot Number CRU Type
1 Maintenance PIC
2,3 Dual SMF or Quad MMF. (Used for zone-to-zone connections.)
4,5,10 Router Interconnect
6,7,8,9 Dual SMF. (Used for switch-to-node connections.)
11,12,13 Quad MMF. (Used for layer-to-layer connections.)
14 Switch logic board
15 and 18 Switch power supplies
16 and 17 Switch fans