ServerNet Cluster 6780 Operations Guide (G06.28+, H06.05+)

SCF Commands for the External ServerNet SAN
Manager Subsystem
ServerNet Cluster 6780 Operations Guide—525606-003
5-38
STATUS SWITCH Command Example
Last Hard Rset
indicates the time (in Greenwich mean time) of the last hard reset command.
Last Soft Rset
indicates the time (in Greenwich mean time) of the last soft reset command.
Soft Reset SrcSNID
is the ServerNet ID of the client that issued a soft reset command if the last reset
command was a soft reset.
Hardware Data ID
indicates whether the previous hardware data identifier (HDI) matches the loaded
HDI after a soft reset.
Firmware Exception
indicates the last cause, if any, of a firmware exception that induced a soft reset.
Firmware Image A
indicates the condition of the firmware stored in Image A of the switch. Two images
are stored for fault tolerance. Possible values are ok, CRC ERROR, and UNKNOWN.
Firmware Image B
indicates the condition of the firmware stored in Image B of the switch. Two images
are stored for fault tolerance. Possible values are ok, CRC ERROR, and UNKNOWN.
FPGA Image A
indicates the condition of the Field-Programmable Gate Array (FPGA) stored in
Image A of the switch. Two images are stored for fault tolerance. Possible values
are ok, CRC ERROR, and UNKNOWN.
FPGA Image B
indicates the condition of the Field-Programmable Gate Array (FPGA) stored in
Image B of the switch. Two images are stored for fault tolerance. Possible values
are ok, CRC ERROR, and UNKNOWN.
Config Image A
indicates the condition of the configuration stored in Image A of the switch. Two
images are stored for fault tolerance. Possible values are ok, CRC ERROR, and
UNKNOWN.